Skip to content

Learn how to prepare and apply BIOnoDUST and estimate the quantity needed for your ground.

BIOnoDUST is mixed with water and applied using watering or spraying equipment. The quantity required depends on the area, surface characteristics and operating conditions.

Concentration and consumption

The indicative concentration is 2.5% to 3.5% by mass (w/w), applied at 1.5 to 2.5 litres of prepared mixture per m². Adjust these values to the ground material, traffic intensity and weather conditions.

ScenarioPrepared mixture per m²Concentration by massBIOnoDUST per 1,000 m²
Light1.5 L2.5%37.5 kg
Medium2.0 L3.0%60 kg
Heavy2.5 L3.5%87.5 kg
Approximate quantities for one application, assuming a mixture density of 1 kg/L and allowing no extra for losses. The w/w percentage is the mass of product as a proportion of the total mixture mass.

Worked example

A road 200 m long and 5 m wide covers 1,000 m². Under the medium scenario, estimated consumption is 2,000 litres of prepared mixture and approximately 60 kg of BIOnoDUST, using the density assumption above.

The calculator lets you adjust the area, number of applications and allowance for losses to suit the operation.

Preparation and application

  1. Prepare the surface. Level the ground, remove excessive loose material and check drainage. Avoid application on saturated surfaces or standing water.
  2. Prepare the mixture. Add water to the tank and start agitation or recirculation. Introduce BIOnoDUST gradually, allow it to hydrate and mix until uniform, following the preparation instructions.
  3. Apply evenly. Distribute the mixture using a water bowser with a spray bar or another suitable spraying system. Where necessary, divide the total quantity into two to four light passes, preventing runoff into watercourses and drainage systems.
  4. Allow drying and stabilisation. Let the treated surface dry and stabilise before traffic resumes. During this process, BIOnoDUST helps fine particles bind together. Check the actual ground conditions before reopening.

Plan application when heavy rain is not imminent and avoid strong wind that affects even distribution.

Durability and reapplication

Performance mainly depends on traffic intensity, weather and ground characteristics. Monitor the surface for the return of dust, particularly in the most heavily used areas.

Adjust reapplication to the actual condition of the ground. For larger areas, start with a trial on a representative section.

Calculate how much BIOnoDUST you need

Estimate product consumption for your area, taking account of the surface and application conditions.

Enter the total surface area to apply.
Use 1 for a single application or increase for re-applications.
Automatically sets the water volume and dosage.
Used to estimate the number of bags needed.
Recommended: 5% to 10%, depending on wind, roughness and application method.

Estimated result

Required water / slurry volume
—
BIOnoDUST required
—
Estimated number of bags
—
Specific consumption
—
Consumption per 1000 m²
—
Estimated area per bag
—
Application rate used
—
Dosage used
—
TypeApplicationDosageConsumption / 1000 m²25 kg bags10 kg bags
Light1.5 L/m²2.5%37.5 kg24
Medium2.0 L/m²3.0%60.0 kg36
Reinforced2.5 L/m²3.5%87.5 kg49
Technical note: The values shown are pre-sizing estimates. Actual consumption may vary depending on grain size, fines content, compaction, humidity, roughness, slope, wind, traffic and the surface's infiltration capacity. For critical applications, a trial on a pilot section is recommended before general application.

Applications across different sectors

Explore the guidance for each setting.

Chat on WhatsApp Other contact options